01GH vs KH in one minute
GH (general hardness) is mostly calcium and magnesium. Shrimp pull both from the water to harden a new shell after a molt. Too little and the shell forms soft; too much and osmoregulation gets harder, especially for bee shrimp.
KH (carbonate hardness) is the buffer, usually reported as carbonates and bicarbonates. It resists pH changes. A tank with KH 0 has almost no buffer, so pH can fall overnight; a tank with high KH holds pH up and fights an acidic substrate.
They are measured separately because they do separate jobs. "Hard water" in a shop conversation can mean either one.
02Targets by species
| Species group | GH | KH | Notes |
|---|---|---|---|
| Caridina bee (Crystal Red, Taiwan bee) | 4–6 dGH | 0–1 dKH | Published KH goes to 2; keep it at 0–1 with active soil |
| Neocaridina (cherry and morphs) | 6–10 dGH | 2–8 dKH | Published GH 4–12, KH 2–15; wider band, same need for stability |
| Amano (Caridina multidentata) | 6–10 dGH | 1–6 dKH | Hardier; not a KH-0 bee tank |
| Babaulti (Caridina babaulti) | 4–14 dGH | 0–12 dKH | Published figures conflict; match the seller's water, change slowly |
Sources: [1] ShrimpKeepers, [2] Pete's Aquatics, [3] The Shrimp Guide, [4] Buce Plant, [5] Razz Aquatics, [6] Tropical Treasures Wyo, [7] Aquairi, [8] Shrimp Up Aquatics.
03Units and conversion
Liquid kits usually report dGH and dKH (German degrees). Some report ppm as CaCO3. The conversion is a definition, not a shrimp-specific number:
- 1 dGH = 17.86 ppm CaCO3 equivalent
- 1 dKH = 17.86 ppm CaCO3 equivalent
So GH 6 is about 107 ppm as CaCO3. If a test strip gives you a number between 100 and 150 and calls it "hardness", check which unit and which scale it means before you adjust anything.
A TDS meter is not a hardness test. It counts everything dissolved — minerals, fertilizer, waste. TDS can rise while GH stays flat. Use TDS as a trend line, not as a substitute for GH and KH.
04What raises GH
GH comes up when you add calcium and magnesium. In practice:
- GH remineralizer made for shrimp or RO water. Dose to the target, mix it fully, then test.
- Calcium sulfate and magnesium sulfate for keepers who mix their own. This is cheaper but easier to get wrong.
- Tap water with high GH. If your tap is already at target, you may not need to add anything.
Do not use aquarium salt as a GH booster. It adds sodium chloride, not the minerals shrimp need.
05What raises KH
KH comes up when you add bicarbonate or carbonate:
- Baking soda (sodium bicarbonate) raises KH quickly and is the usual emergency buffer. It also adds sodium, so use it as a tool, not a routine.
- KH buffer products for planted tanks. Check the label; some also raise pH more than you want.
- Crushed coral or limestone dissolves slowly and holds KH up. Hard to remove once it is in the tank.
For Caridina, raising KH is almost always the wrong move. If KH is above 1 in a bee tank, find out why before adding anything: the substrate may be exhausted, or the remineralizer may contain carbonate.
06How to lower hardness
The safe way to lower GH or KH is dilution with RO or distilled water. Change 10–20% at a time, match the temperature, and test before the next change.
Avoid:
- Water softener pillows — they exchange calcium for sodium and do not lower TDS.
- pH-down chemicals — they fight the buffer and create swings.
- Large water changes — a fast drop is worse than a stable high number.
If your tap is far outside the target, mixing 50/50 with RO is usually cheaper and more predictable than treating every drop.
07Test routine
- Test GH and KH with liquid reagents, not strips, when you are making decisions.
- New tank: test twice a week for the first month.
- Established tank: once a week, same day, before feeding.
- Log the number, the date and what you changed. A trend beats a single reading.
- Test the water you add, not only the tank. A water change with the wrong GH undoes a month of stability.
08Four mistakes
- Treating TDS as hardness. It is a different measurement.
- Chasing a pH number with KH chemicals. Set KH, and pH follows.
- Using KH buffer in a Caridina tank. It fights the soil and pushes pH up.
- Changing two things at once. If GH and KH both move, you will not know which caused the molt.
09FAQ
Is hard water bad for shrimp?
Not by itself. The problem is a value outside the species band, or a fast change. Neocaridina handle harder water than Caridina.
What GH do cherry shrimp need?
A practical target is 6–10 dGH. Published guides span 4–12 dGH, so a stable tank inside that spread is usually fine.
Can I raise GH without raising KH?
Yes. Use a GH-only remineralizer or calcium and magnesium sulfate. Baking soda raises KH, not GH.
Why does my GH rise on its own?
Top-offs with tap water, mineral-heavy food, and evaporation all concentrate minerals. Top off with RO water and test the tank, not the top-off container.
Do I need a TDS meter?
Useful for spotting drift, but it does not replace GH and KH kits. Keep both if you keep Caridina.
10Sources
All accessed 19 November 2026. Unit conversions are definitions (1 dGH = 17.86 ppm CaCO3), not species data. Published ranges differ; the table gives the band used on this site and states the spread where sources disagree.
- ShrimpKeepers, Caridina Shrimp Water Parameters: pH, GH, KH Guide. pH 6.0–6.8, GH 4–6, KH 0–1, TDS 100–200 (120–150 optimal), 68–75°F with 70–72°F ideal; Shadow Panda sub-range. Accessed 2026-11-19.
- Pete's Aquatics, A Guide to Perfect Water Parameters for Caridina Shrimp Tank. pH 6.0–6.8, GH 4–6, KH 0–2, TDS 100–200, 70–74°F. Accessed 2026-11-19.
- The Shrimp Guide, Shrimp Water Parameters Chart by Species. Caridina pH 5.8–7.0, GH 4–6, KH 0–2, TDS 90–150; Crystal Red and Taiwan Bee pH 5.8–6.8, TDS 100–130; remineralizing RO to GH 4–6 and KH 0. Accessed 2026-11-19.
- Buce Plant, A Guide for Keeping Freshwater Shrimp. Caridina 64–76°F, pH 6–7.5, TDS 100–200, GH 4–6, KH 0–2; Neocaridina 65–84°F, pH 6.5–8.0, TDS 200–300, GH 4–8, KH 3–15. Accessed 2026-11-19.
- Razz Aquatics, Neocaridina Water Parameters: GH, KH, pH & TDS. Neocaridina 68–78°F, pH 6.5–8.0, GH 6–12, KH 2–8. Accessed 2026-11-19.
- Tropical Treasures Wyo, Shrimp Water Parameters Guide: GH, KH, pH, TDS & Temperature. Caridina 65–74°F and KH 0–2; Amano pH 6.5–7.5, GH 6–10, KH 1–6, TDS 150–300, 70–78°F. Accessed 2026-11-19.
- Aquairi, Caridina babaulti Breeding Guide. Babaulti 21–27°C, pH ~6.8–7.8, GH ~4–14, KH up to ~12, TDS ~50–250 — reported figures, wide spread. Accessed 2026-11-19.
- Shrimp Up Aquatics, Amano Shrimp Water Parameters: pH, TDS, GH, KH & Temperature. Amano 68–78°F, pH 6.5–7.8, stable KH, 0 ppm ammonia and nitrite. Accessed 2026-11-19.