Independent shrimp-keeping reference No affiliate links · Parameters cited
Reference chart

Shrimp Water Parameters

GH, KH, pH, TDS and temperature for the shrimp people actually keep — compared in one chart, with the source behind every range.

Updated 19 November 2026 3 species groups 8 cited sources

Quick targets

Caridina (bee)
68–72°FpH 6.0–6.8 · GH 4–6 · KH 0–1
Neocaridina
68–78°FpH 6.5–8.0 · GH 6–10 · KH 2–8
Amano
68–78°FpH 6.5–7.8 · GH 6–10 · KH 1–6

Full ranges, TDS and evidence notes are in the table below. Every group also has a dedicated page.

01Master chart

Three groups cover almost every freshwater shrimp sold for planted tanks. The chart gives a working target for each; the linked pages explain how to reach it.

Working targets. GH and KH in degrees, TDS in ppm, temperature in °F.

Group Temp pH GH KH TDS Substrate
Caridina — bee lines Crystal Red, Crystal Black, Taiwan Bee 68–72°F20–22°C 6.0–6.8 4–6 0–1 110–150 Active buffering soil
Neocaridina Cherry, Blue Dream, Yellow, Green Jade 68–78°F20–26°C 6.5–8.0 6–10 2–8 180–280 Inert gravel or sand
Amano Caridina multidentata 68–78°F20–26°C 6.5–7.8 6–10 1–6 150–300 Inert, planted

Published ranges are wider than these targets. The notes on each species page list the full spread and where the sources disagree.

02The three numbers that matter

Most water problems come down to GH, KH and pH. Temperature and TDS are easier to hold steady, and ammonia is a yes/no check.

GH — general hardness

Calcium and magnesium, measured in degrees of general hardness. Shrimp pull both from the water to harden a new shell after a molt. Caridina bee lines need 4–6 dGH; Neocaridina do well at 6–10.[1][4]

KH — carbonate hardness

The buffer that resists pH change. Bee shrimp are kept at 0–1 dKH so an acidic substrate can hold pH in the low 6s. Neocaridina are fine at 2–8 dKH, which is why they work in ordinary tap water.[3][5]

pH — and why it follows KH

pH is the result, not the lever. In a low-KH tank the substrate sets pH. In a high-KH tank carbonate locks pH near 7.5–8.0. Adding pH-down to a high-KH tank produces a swing, not a stable number.

Rule of thumb

Match the species to your water before you buy. Changing KH means changing your water source — usually to RO plus a remineralizer — not adding a bottle to the tank.

03Which shrimp for your water

Choose by tap water, not by color.

Your water Best fit Why
Soft and acidic (GH 4–6, KH 0–1) Caridina bee lines Matches their natural range; an active substrate keeps it stable
Medium hard (GH 6–10, KH 2–8) Neocaridina Broad tolerance; inert gravel is fine
Hard and alkaline (GH 10+, KH 8+) Neocaridina, or RO for Caridina Bee shrimp will not breed reliably; treat RO or choose Neocaridina
Planted community tank, 72–78°F Amano Hardy algae grazer; not a breeding project in freshwater

Cherry shrimp are the usual first colony because they tolerate the widest range. The Neocaridina page covers them in detail.

04Testing routine

You do not need a lab. A TDS pen and three liquid tests cover almost everything that goes wrong in a shrimp tank.

Minimum routine for a stable colony.

Test Tool Frequency Reading to act on
TDS TDS pen Every 1–2 days Rising trend, not a single number
pH Liquid kit or calibrated pen 2–3× per week Drift of more than 0.3 in a week
GH / KH Liquid drop kit Weekly GH below target, KH above target
Ammonia / nitrite Liquid drop kit Weekly; daily after any death Anything above 0 ppm
Nitrate Liquid drop kit Weekly Above 20 ppm

Test at the same time of day. pH moves with the CO2 cycle, so a morning reading and an evening reading are not comparable.

05Symptom → likely cause

Start here when something is wrong. Confirm with a test before dosing anything.

What you see Check first Usual fix
White ring, shrimp stuck in old shell GH, KH Raise GH slowly to the species target; check KH is not too high
Deaths after a water change Temperature, TDS, chlorine Match water, use dechlorinator, smaller changes
pH climbing week after week KH, substrate age Switch to RO + GH-only salt; replace spent substrate
TDS rising with no dosing Top-off water, feeding Top off with plain RO; cut feeding
Berried females but no shrimplets GH, KH, temperature Bring parameters into band and stop changing them

06Sources

Ranges are compiled from the published guides below and cross-checked against each other. They are not laboratory measurements, and they are not a substitute for testing your own water.

  1. ShrimpKeepers, Caridina Shrimp Water Parameters: pH, GH, KH Guide. pH 6.0–6.8, GH 4–6, KH 0–1, TDS 100–200 (120–150 optimal), 68–75°F with 70–72°F ideal; Shadow Panda sub-range. Accessed 2026-11-19.
  2. Pete's Aquatics, A Guide to Perfect Water Parameters for Caridina Shrimp Tank. pH 6.0–6.8, GH 4–6, KH 0–2, TDS 100–200, 70–74°F. Accessed 2026-11-19.
  3. The Shrimp Guide, Shrimp Water Parameters Chart by Species. Caridina pH 5.8–7.0, GH 4–6, KH 0–2, TDS 90–150; Crystal Red and Taiwan Bee pH 5.8–6.8, TDS 100–130; remineralizing RO to GH 4–6 and KH 0. Accessed 2026-11-19.
  4. Buce Plant, A Guide for Keeping Freshwater Shrimp. Caridina 64–76°F, pH 6–7.5, TDS 100–200, GH 4–6, KH 0–2; Neocaridina 65–84°F, pH 6.5–8.0, TDS 200–300, GH 4–8, KH 3–15. Accessed 2026-11-19.
  5. Razz Aquatics, Neocaridina Water Parameters: GH, KH, pH & TDS. Neocaridina 68–78°F, pH 6.5–8.0, GH 6–12, KH 2–8. Accessed 2026-11-19.
  6. Tropical Treasures Wyo, Shrimp Water Parameters Guide: GH, KH, pH, TDS & Temperature. Caridina 65–74°F and KH 0–2; Amano pH 6.5–7.5, GH 6–10, KH 1–6, TDS 150–300, 70–78°F. Accessed 2026-11-19.
  7. Aquairi, Caridina babaulti Breeding Guide. Babaulti 21–27°C, pH ~6.8–7.8, GH ~4–14, KH up to ~12, TDS ~50–250 — reported figures, wide spread. Accessed 2026-11-19.
  8. Shrimp Up Aquatics, Amano Shrimp Water Parameters: pH, TDS, GH, KH & Temperature. Amano 68–78°F, pH 6.5–7.8, stable KH, 0 ppm ammonia and nitrite. Accessed 2026-11-19.